Ford C-Max Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter #1
Can anybody advise if they have added Rear Parking sensors on C-Max Zetec (05)?

Know that this is possible using a universal unit from ebay however wanted to know if anybody had gone down this route.

Regards
 

·
Registered
Joined
·
336 Posts
Hi not yet just about to do it for the front and the back. Only difference is i will wire a switch to dash to turn on fronts manually. I will be buying 2 sets i think rather than a universal set with front and back sensors.
 

·
Registered
Joined
·
4 Posts
Discussion Starter #3
Sounds like a great idea. Love to know how you got on and your overall opinion of fitting etc.
 

·
Registered
Joined
·
1 Posts
Yeah!

I did it a couple of weekends ago on my wifes 55 plate Cmax. Used a kit from ebay (link below)

http://cgi.ebay.co.uk/Rear-Car-Parking-Reversing-Sensors-4-Sensor-Buzzer-Kit_W0QQitemZ320264782806QQihZ011QQcategoryZ75330QQssPageNameZWDVWQQrdZ1QQcmdZViewItem

Took less than an hour to install and works great! installed them in the black plastic bit of the rear bumper and used the supplied collars to make sure they sat straight.

Then removed the gromit above the exhaust and ran the cables upto behind the top interior trim pannel.

If i get a chance i will take some pics and post them here later.

Hope this helps people.

Pete
 

·
Registered
Joined
·
2 Posts
@pdherring


I'd like to do the same, it doesn;t sound very difficult.

So you've installed the sensors in the plastic trim underneath the body colured bumer right?
Also did you have to fully remove this trim or did you drill the holes while the trim was still attached to the car?

Thank you for your time...
 
1 - 5 of 5 Posts
Top